![]() |
SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
AWD not working properly
only front wheels are spinning no rear wheel drive. i figured this out by first getting stuck in mud and only one front tire was spinning and in rain tire breaks loose in the front when downshifting into first or hard acceleration. can hear a constent buzzing when car is on and in drive, which from researching other threads means that solenoid c is working properly. im not getting a power light either. what are other test i can preform to figure this out. and there is no fuse in fwd slot.
|
#2
|
||||
|
||||
Re: AWD not working properly
Someone didn't steal your driveshaft, did they?
![]() Seriously, if you're confident that the solenoid C is good, then the next probable cause is that the clutch pack is shot. Getting to the clutch pack is the same as getting to the solenoid C (remove back of trans - you don't have to remove the entire trans). Have you tried pulling transmission codes? -Bill ![]()
__________________
Retired NASA Rocket Scientist Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023 Center Network Member #989 '92 Fully caged, 5 speed, waiting for its fully built EG33 '92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension '92(?) Laguna, 6 spd and other stuff (still at OT's place) My Locker Last edited by SVXRide; 12-27-2009 at 12:47 PM. |
#3
|
||||
|
||||
Re: AWD not working properly
Don't laugh, Bill. I've seen it! ![]() The AWD was borked, so They left only the front half so that the transmission would not leak ATF!
__________________
www.svxfiles.com The first SuperCharged SVX, ![]() the first 4.44 gears, the first equal length headers, the first phenolic spacers, the first Class Glass fiberglass hood, the first with 4, 4.44s in his driveway ![]() Fiberglass Hood thread My locker 4.44 Swap link |
#4
|
||||
|
||||
Re: AWD not working properly
Quote:
There are evil folks out there! Hey, did you recognize the pic in my post? Took it when you did the solenoid C replacement in the stock trans in Racer X (seems like a long time ago...) -Bill
__________________
Retired NASA Rocket Scientist Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023 Center Network Member #989 '92 Fully caged, 5 speed, waiting for its fully built EG33 '92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension '92(?) Laguna, 6 spd and other stuff (still at OT's place) My Locker |
#5
|
||||
|
||||
Re: AWD not working properly
![]() Quote:
Oh, yea, sure I remember that one time I had an SVX trans apart. ![]() That picture sure takes me back... ![]()
__________________
www.svxfiles.com The first SuperCharged SVX, ![]() the first 4.44 gears, the first equal length headers, the first phenolic spacers, the first Class Glass fiberglass hood, the first with 4, 4.44s in his driveway ![]() Fiberglass Hood thread My locker 4.44 Swap link Last edited by svxfiles; 12-27-2009 at 01:20 PM. Reason: I'm not sure if this post was sarcastic enough.:rolleyes: |
#6
|
||||
|
||||
Re: AWD not working properly
Quote:
![]() ![]() -Bill
__________________
Retired NASA Rocket Scientist Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023 Center Network Member #989 '92 Fully caged, 5 speed, waiting for its fully built EG33 '92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension '92(?) Laguna, 6 spd and other stuff (still at OT's place) My Locker |
#7
|
||||
|
||||
Re: AWD not working properly
lol i wish someone stole it probly be alot similar fix.
there are no codes to pull power light doesnt flash, but it does when its cold because of lack of vaccum on the smallcar shift kit. From the research ive done i think im just going to replace both while its out. any suggestions on good name brands for the clutch pack and solenoid or just go with dealership parts. do u know where to get any detail info on replacing the clutch pack? going to the shop right know to look at what it is all going to take and to look it all over for any simple problems. and i did i trans flush and changed the trans filter about a month or so ago and put mobile1 back in it. dont think i could of done something while pan was off? |
#8
|
||||
|
||||
Re: AWD not working properly
Quote:
-Bill
__________________
Retired NASA Rocket Scientist Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023 Center Network Member #989 '92 Fully caged, 5 speed, waiting for its fully built EG33 '92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension '92(?) Laguna, 6 spd and other stuff (still at OT's place) My Locker |
#9
|
||||
|
||||
Re: AWD not working properly
Quote:
![]() P.S. I note that you have a Small Car shift kit fitted. This will not have been doing solenoid "A" any good and as a result line pressure may be down. In any event this is worth checking as of routine, before rushing into bigger things.
__________________
Trevor, New Zealand. As a child, on cold mornings I gladly stood in cowpats to warm my bare feet, but I detest bull$hit! ![]() Last edited by Trevor; 12-28-2009 at 03:03 AM. Reason: P.S. |
#10
|
||||
|
||||
Re: AWD not working properly
Best place for a Small Car shift kit would be fitted in the trash...
Keith ![]() |
#11
|
||||
|
||||
Re: AWD not working properly
Pretty sure the dealership is the only place to get the transfer clutch kit I know even rebuild kits don't come with these clutches. If you messed the wires up when changing the filter then you would see a code... to truly diag this problem you need to pressure test the line that feeds the clutch pack while all 4 wheels are off the ground... but just replacing the clutch pack with no awd and no codes isn't a bad idea... just not the best idea
__________________
- John ASE certified Master Tech W/ X1 Twin City Fleet repair, St. Paul, MN need work done? Have tools will travel
|
#12
|
|||
|
|||
Re: AWD not working properly
hi dont forget the teflon seals when working on the transfer clutches
also inspect the hub and drive housing for knotches worn in to them which makes it hard to have the clutches move ,there is a up dated kit that is in 2 TSBs along with new clutch packs charlie |
#13
|
|||
|
|||
Re: AWD not working properly
soa plate kit #31523AA170 this number changes to 330 then a 460
retail 176.43 |
#14
|
||||
|
||||
Re: AWD not working properly
took to transmission shop turned out being the drum broke? $1200 fix......
![]() |
#15
|
|||
|
|||
Re: AWD not working properly
tires should be the same size and tread ,if your off more then 1/2 in rolling size it will effect your all wheel drive system ,just because a tire says 225/50 r16 different manufactures can be 2 1/2 different in rolling size
|
![]() |
|
|