Vaccuum hose question

[blue thunder]

I was putting in a new starter motor a few days ago and I pulled the hose out that goes to the black plastic box that clamps onto the throttle body to give me more room to maneuver. When I was done putting the starter in I put the hose back on and noticed the other end had broken off that goes to the engine area. The hose is about .700 diameter or so just looking at it. Around sixteen to eighteen inches long total. It has an elbow at each end forming a long u shape. I was able to reach under the manifold and pull off the end piece that remained. About an inch or less. Advance only had a straight hose line I could try. Well I can't even find the connection now that goes in the engine area and not sure if I have enough room to bend the hose to make it work without crimping it to much. Does anyone know where I can get an OEM hose line? A part number? I shined a light in they're and can't see where it plugs in. Any advice on this appreciated.

Mike