SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
Transmission mount
Finally putting the built motor back in the car. Silly question though. Its been a while since I've taken out the transmission mount nuts. There are two on each side and one center nut with a rubber backed washer on the center. it seems like it is too thin to fit but up against the bottom of the mount. Anyone know what's going on? It almost seems like the tranny is sitting too low if that is possible. Anyway the rubber backed washer will not fit over the unthreaded part of the bolt. Sorry to not describe this better.
Chuck
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
#2
|
||||
|
||||
Re: Transmission mount
That is how they are suposed to fit, with a gap between the castle washer and the crossmember.
__________________
www.svxfiles.com The first SuperCharged SVX, the first 4.44 gears, the first equal length headers, the first phenolic spacers, the first Class Glass fiberglass hood, the first with 4, 4.44s in his driveway Fiberglass Hood thread My locker 4.44 Swap link |
#3
|
|||
|
|||
Re: Transmission mount
Awesome. Thanks. Its been a while since I took this off.
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
|
|