SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
|
#1
|
||||
|
||||
How to replace engine mounts?
Here I am once again completely dumb-founded about how to get out the engine mounts on my SVX. Just put a new engine installed and now the driver side mount is broken. Please do not tell me I have to take the engine out again.
__________________
ALL WAYS JUDO CHOPIN' "Wait...your grill...is that chicken wire?" |
#2
|
||||
|
||||
Re: How to replace engine mounts?
I just did this. You don't have to take the engine back out. Disconnect the motor mounts (lower nut) and the dogbone mount and jack or lift up the motor and you can get the old ones out and new ones in. Exhaust was not connected to the exhaust manifolds when I did it.
__________________
'94 Laguna Blue LSi ~159k.......JDM ultra short-geared 3.900 STi Version 7 6-speed w/ Cobb shortshifter, ECUtune 244,8.1mm/256,9.1mm i/e cams, group N motor mounts, '97 grille, JDM clear corners, Momo JDM Legacy GT steering wheel, apkarian's LED tails, silver STi BBS wheels, PWR radiator, redstuff pads f/r, drilled/slotted rotors, bontragerworks rsb #18, Koni/GC 450f/375r coilovers, Megan Racing adjustable lateral links, KMac c/c plates, Stebro exhaust, ECUtune 1v5, Optima battery in the trunk where it belongs. Turbo project '97 Ebony LSi ~137k #036.......Power mode mod, JDM clear corners, BBS wheels. AUX/pocket mod Now a mod "over there" ............Photo album |
#3
|
||||
|
||||
Re: How to replace engine mounts?
What is a dogbone mount? I tried to take out the the screws that held the mount bracket but the last screw that goes point towards the fire wall can not be reached. It is covered by the sub. Is there an easier way to get to it?
__________________
ALL WAYS JUDO CHOPIN' "Wait...your grill...is that chicken wire?" |
#4
|
||||
|
||||
Re: How to replace engine mounts?
Dogbone mount = upper pitch mount where it connects to the front top of the transmission. You most likely would have had to disconnect this at some point in order to take the motor out.
__________________
'94 Laguna Blue LSi ~159k.......JDM ultra short-geared 3.900 STi Version 7 6-speed w/ Cobb shortshifter, ECUtune 244,8.1mm/256,9.1mm i/e cams, group N motor mounts, '97 grille, JDM clear corners, Momo JDM Legacy GT steering wheel, apkarian's LED tails, silver STi BBS wheels, PWR radiator, redstuff pads f/r, drilled/slotted rotors, bontragerworks rsb #18, Koni/GC 450f/375r coilovers, Megan Racing adjustable lateral links, KMac c/c plates, Stebro exhaust, ECUtune 1v5, Optima battery in the trunk where it belongs. Turbo project '97 Ebony LSi ~137k #036.......Power mode mod, JDM clear corners, BBS wheels. AUX/pocket mod Now a mod "over there" ............Photo album |
#5
|
||||
|
||||
Re: How to replace engine mounts?
Okay got the mount out and will replace it with with the spare one that I have from my old car. Do you know if there is any there performance type mounts out there?
__________________
ALL WAYS JUDO CHOPIN' "Wait...your grill...is that chicken wire?" |
#6
|
|||
|
|||
Re: How to replace engine mounts?
Group N solid mounts, or any engine mount for almost any EJ Subaru.
|
#7
|
||||
|
||||
Re: How to replace engine mounts?
I like the group N ones. Click the link in my sig.
__________________
'94 Laguna Blue LSi ~159k.......JDM ultra short-geared 3.900 STi Version 7 6-speed w/ Cobb shortshifter, ECUtune 244,8.1mm/256,9.1mm i/e cams, group N motor mounts, '97 grille, JDM clear corners, Momo JDM Legacy GT steering wheel, apkarian's LED tails, silver STi BBS wheels, PWR radiator, redstuff pads f/r, drilled/slotted rotors, bontragerworks rsb #18, Koni/GC 450f/375r coilovers, Megan Racing adjustable lateral links, KMac c/c plates, Stebro exhaust, ECUtune 1v5, Optima battery in the trunk where it belongs. Turbo project '97 Ebony LSi ~137k #036.......Power mode mod, JDM clear corners, BBS wheels. AUX/pocket mod Now a mod "over there" ............Photo album |
|
|