![]() |
SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
Rear axle question
Was trying to loosen cover plate on inner end of rr axle as it goes into the diff, held with 5 12mm bolts. With bolts off and a goodly bit of prying, it didn't budge. Is this a matter of needing to "persuade" it a bit more vigorously or am I missing something?
THX |
#2
|
||||
|
||||
Re: Rear axle question
After you remove the 5 EIGHT MM bolts with the TWELVE MM heads, gently try to rotate the side plate using a square drift, if you have one and a small hammer.
Once you start to twist it/rotate it it should be able to be twisted off.
__________________
www.svxfiles.com The first SuperCharged SVX, ![]() the first 4.44 gears, the first equal length headers, the first phenolic spacers, the first Class Glass fiberglass hood, the first with 4, 4.44s in his driveway ![]() Fiberglass Hood thread My locker 4.44 Swap link |
#3
|
||||
|
||||
Re: Rear axle question
As always, much appreciated...will follow those tips.
|
#4
|
||||
|
||||
Re: Rear axle question
Sure.
![]() BTW, "Torque the side plates to 6.5-8.7 ft/lb."
__________________
www.svxfiles.com The first SuperCharged SVX, ![]() the first 4.44 gears, the first equal length headers, the first phenolic spacers, the first Class Glass fiberglass hood, the first with 4, 4.44s in his driveway ![]() Fiberglass Hood thread My locker 4.44 Swap link |
![]() |
|
|