[svxfiles]

Originally Posted by pearlm30

I was trying to locate the squeaky sound from the rear part of trany on my 94 FWD. Turned out the 2 bolts that bolt the trany mount to the rear trany case cover striped the holes inside. Who ever did the last trany removal screwed it up!!!
My question are
1)Can I repair the thread? YES
I hear about so call Heli-Coil, but dont really know how to use it?
They come with instructions
What about just JB weld it? I would not.
Would it hold????
2)Or I need to just replace the tail housing cover plate where the trany mount was bolted to? That would be best.
Its 94 FWD, so it didnt have the drive shaft coming out of it.
3)Is this trany same as Legacy's? Very close.
Can I swap the cover plate with a FWD legacy?Yes!
If not, I will post a seprate post in wanted forum
Thanks for the help!

BTW, I have that plate.