Quote:
Originally Posted by immortal_suby
Bought a 7,000 rpm 500 lb-ft twin hammer today. Got the right side off, but the left side still won't budge. I threw some PB blaster on there, will try again later. I'll try that trick with taking the valve covers off to hold the sprocket. There was no rust or any sign of anything on the bolt I took out. Must be just on there tighter than hell. If I can hold it in place with the valve cover off I'll put a 3 foot breaker bar on my 1/2 inch drive and try that too.
I got the boxes from you today and the paypal.
|
A 500 lb-ft gun won't get it off?!?
That's a bit nuts.
If you're really stuck, there's always this guy for the job:
http://www.irtools.com/IS/product.asp-en-2916
I can't think of much that 80,000 lb-ft won't turn.