|
Re: pulling my rear diff cover??
If you look at the rear of the diff, at the top, you'll see two BIG bolts that go through the subframe. They're inside some rubber bushings. Those bolts go all the way through the diff. Through the cover and everything. To remove the cover you have to take the nuts off those big bolts, then remove the entire diff from the car (or at least get it out from where it is a little bit), then you can slide the cover backwards off those bolts.
A lot of work. Just take a razor and shave the excess silicon off where it squeezed out. Same results, much less time.
Edit: Ack, Dave beat me to it. *shakes fist*
__________________
Chris
92 Ebony Mica LS-L " A Rolling Restoration": 223,250 KM - Sleeping
2007 STi 6MT, Stance GR+ coilovers, PWR Rad, JDM hood badge, svxfiles 6000K HIDs, JDM Clear Corners, $15/15 min mod, $20/20 min mod, Energy Swaybar Bushings, Hella Supertones horns, Gold STi BBS rims, Group A lightweight crank pulley, A/C system removed, Custom header-back exhaust, Hybrid carbon/metal rear sway bar, restored headlights with CCFL halos
2008 Subaru Legacy Spec B - Diamond Grey Metallic - Sold
2020 Ram 1500 Longhorn - Red Pearl
|