eg33 stroked to 3.7??

[porschekiller]

lunati will take the stock forged crank and customize it up to 3.82 inches for a sqare bore and 4.3L

Originally Posted by crazyhorse

From what I've seen of the EG33's engine block, the open deck design may be the limiting factor in boosting it. The cylinders in an open deck block tend to "squirm" under boost. "O" ringing it will help, but to get the numbers you're talking about, I'm not sure that'd be sufficient.

Yes stroking the EG33 would only involve the crank & rods. The $64 question is, where would you source the crank? Are you saying that the Porsche engine has the exact same bearing spacing/diameter? The thoughts of an EG37 are VERY intriguing.