SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
Need Pinion Gear!!!
I need the ring and pinion gears from a stock 4EAT to replace my broken ones. It's no longer availible through any subaru part dealers. they are labeled #1 in the diagram. PLEASE HELP ASAP!!!
__________________
-Nate '92 LS-L Pearlie Last edited by Sir. Nate; 05-08-2008 at 12:43 PM. |
#2
|
||||
|
||||
Though I am sure we have one around, have you tried Jackie at Annapolis Subaru? YT and I order from her all of the time. SVXWN gets a discount...
I will check with YT to see what we have in the shop.
__________________
1991 SVX L JDM |
#3
|
||||
|
||||
I did a little research and subaru parts.com has them for a 1997, would this be the same for a 1992? Also, what about a 4.11 trans makes it a 4.11? Is it just the ring and pinion in the front gearbox? Thanks Mike, It'd be awesome if you guys had a good used set in your shop.
__________________
-Nate '92 LS-L Pearlie Last edited by Sir. Nate; 05-08-2008 at 01:51 PM. |
#4
|
||||
|
||||
Yea we have some here if you need it. And yes, just the ring and pinion decide the final drive ratio, be it 3.545, 3.70. 3.90, 4.11, or 4.444
Tom |
#5
|
||||
|
||||
Sweet, what ratios do you have on hand? And what prices as well?
__________________
-Nate '92 LS-L Pearlie |
#6
|
||||
|
||||
we only have the stock ratio of 3.545. R&P w/ a front diff housing is $275 shipped
Tom |
#7
|
||||
|
||||
I don't need the diff housing, would you sell the gears by themselves?
__________________
-Nate '92 LS-L Pearlie |
#8
|
||||
|
||||
sure, but it is much easier to keep the backlash and pinion depth for this diff rather than have to pre-load the bearings again set the pinion depth and backlash it.... Up to you, either way its the same price as I will just scrap the housing after I remove the gears
Tom |
#9
|
||||
|
||||
Yeah, you're right. I'll hit the easy button. PM sent.
__________________
-Nate '92 LS-L Pearlie |
|
|