SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
I must have messed up my right rear abs sensor
I changed the rear wheel bearing on the passenger side and had a lot of problems getting the abs sensor out, I tried to be careful but it was really stuck bad, I used a thin screwdirver behind the mounting bracket and used PB Blaster on it as well,, and it did finely come out but it did fall from where I had it placed while I was working on the rest of the bearing job. The sensor didn't even want to go back in too good and when I was removing it I bent the little tab where the mounting bolt hole is but it did pull back to normal when I replaced it,, actually I didn't think I did anything to damage the sensor but shortly after I tried the car out the abs light came on and today I checked the code and it shows a (7) as I suspected it would since it worked fine before I did the bearing. I guess I will have to replace the sensor, what I need to know is where is it plugged into the harness? the opposite end of the wire from the sensor end? I can't seem to find it posted anywhere about the location of the connector. also there is a mounting bold that secures the senor wire , I am guessing the connection is somewhere above that and that bold will need to be removed, it lools like there are a couple of connection points but I guess those are just dust boots or something? Thanks Vernon
|
|
|