SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
Tie rod replacement
How do you replace the ball joiint type thing at the end of the tie rods? does the entire tie rod have to be replaced or can you replace just the ball joint type thing?
dustin
__________________
-Dustin 1992 Ebony LS-L w/191k miles Mods: a few and acouple more 1995 Brilliant Red L/AWD w/154k miles Mods: Stebro catback exhaust, K&N drop in filter, ECUtune ST1v5, 4.44, lots of JDM goodies 1992 Pearly LS-L w/154k miles Sold Mods: 4.11, rust 2008 DGM Legacy spec.B w/245k miles Mods: Cryotune Stage3, VF52, bushings galore, STi pink springs, Bilstein HDs My Locker The only man alive who drives three "Subu SVS's".......according to my insurance company |
#2
|
||||
|
||||
the intire tie rod must be replaced and the car needs to be aligned... just loosen up the jam nut and screw the tierod off make sure to count how many turns it takes to get it off so that the alignment will be close enough when you put the new tie rod on you can drive it somewhere to be aligned.
__________________
- John ASE certified Master Tech W/ X1 Twin City Fleet repair, St. Paul, MN need work done? Have tools will travel
|
|
|