SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
How to remove the side molds?
I will take the car to be painted and I was thinking to remove the side molds (left&right, next to the trunk).
Does anybody removed them? I can pull them hard but that may damage some clips or plastic anchors. Can you give me some directions? Thanks. |
#2
|
||||
|
||||
I think you just pull them off. Problem is that the clips that hold them on always break and you have to get new ones.
|
#3
|
||||
|
||||
you wil 99% likely break clips. Breaking clips is fine though, you can get new ones. Is when you break where the clip mounts to the piece that you have problems.
they need to be PUSHED from near the window back toward the trunk to get them off. trunk needs to be open fr this to work. They shold slide mabey a half inch...from there pry the up The drivers side, the antenna mount thing needs to be taken off. Youll see two prongs when you look down at it from the top. Ive found needle nose pliars in the two holes works well..unscrew it, and pull the rubber thing off. The rest of the antenna shouldnt interfere
__________________
R.I.P Cool Signature. You're gone but not forgotten. I mean, sure, I kindof don't remember some of the finer details..but I remember you were funny, and at one point you said spaghetti in Dutch....but definantly not forgotten |
#4
|
||||
|
||||
Quote:
__________________
1992 SVX LS-L #1222 Pearl White 1987 GL Turbo wagon, 5 lug conversion, D/R 5 speed (Rice killer) 1992 Dodge Ram 4x4 diesel (car hauler) 1968 Dodge Polara convertible (Camaro killer) 1990 Toyota Corolla FWD auto (330,000 mile grocery getter) 1986 VW Jetta |
|
|