Loose Regulator Cable

[theflystyle]

So I had the typical issue of the window (drivers side) not going up/down without assistance so I opened up the door to take a look. I figured it would be related to the clip that seems to always fail but they looked good on this door.

I then checked the regulator and all seemed OK, meaning I didnt see anything obviously wrong. But when I checked the tension in the regulator cable there seemed to be a decent amount. Watch the short video clip below and you can see what I am talking about.

CLICK TO PLAY - Note the jerking in the motion is me controlling it from the switch.


So can this be fixed by removing the slack in the cable? Is it done by adjusting the nut on the regulator cable itself?

Thanks