Torque specs for rear housing

[dannmarr]

I took apart the rear housing (knuckle) assembly and had the bearings replaced.
I put everything back together. I now need the torque specs on all the parts that were attached. I have the written specs but I need a photo to help me identify the names of the parts. Can anyone help? I've been searching for an hour so far

[Tapani]

It's all here, with illustrations:

http://www.phantomotaku.com/SVX/MSA5...Suspention.pdf

You may down load all other stuff too:

http://www.phantomotaku.com/SVX

Tapani

[dannmarr]

Tapani,

Thanks! Once I'm done, I'll try to make a diagram with the names and the torques of the parts. I'm sure it will help others too. Thanks again!

[dannmarr]

Here are some photos and Torque specs for the rear housing (Knuckle).
Other specs: Speed sensor=17-31, Caliper=12-17, Caliper support bracket=32-43
These are all Ft Lbs.
Thanks for everyones help!