SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
95 svx dies once warmed up
Working on a 95 svx. This has me just a little baffled..It idles great untill it gets warmed up and goes to closed loop operation..Then it dies up to 5 times. Then it runs fine after that. The mass air flow sensor is new and tests fine,and all the sensors seem to test ok .Antyone have a thought on what next.Plz help!!
|
#3
|
|||
|
|||
Re: 95 svx dies once warmed up
Thank i'll check that out ..Think im just too close to it and over looking minor problems.
|
#4
|
|||
|
|||
Re: 95 svx dies once warmed up
The coolant temp sensor would cause that?
It used to happen to me a lot but these days its getting better |
#5
|
|||
|
|||
Re: 95 svx dies once warmed up
tryed running with out temp sensors today no differance..Test look good,but it learned a new trick today now it has a irradic ideal once it is warm and will keep running about 300-400 rpm. Anyone think cleaning the throttle body might help maybe blocked air passage? I know this is a problem with toyta..
|
#6
|
||||
|
||||
Re: 95 svx dies once warmed up
Are you getting c/e codes on the dash?
Is a vacuum line unplugged on your throttle body? Take a look to see if all hoses are connected. How long ago was your fuel filter replaced? Same with air filter...check that too. |
#7
|
|||
|
|||
Re: 95 svx dies once warmed up
All of the filters and fule pump were just replaced and no there was not a c/e light till the other day when the eradic ideal startered...not that i have read all my books and looked at all the web sites and spent 2hours looking for the test connecter wires or obd2 hook up for my nemisy. do u know where the wires are or the obd2 hook up.????
|
#8
|
|||
|
|||
Re: 95 svx dies once warmed up
All of the filters and fule pump were just replaced and no there was not a c/e light till the other day when the eradic ideal startered...now that i have read all my books and looked at all the web sites and spent 2hours looking for the test connecter wires or obd2 hook up for my nemisy. do u know where the wires are or the obd2 hook up.????Bad netsorry for the second posting
Last edited by acehome; 06-03-2009 at 02:25 PM. Reason: bad net |
#9
|
||||
|
||||
Re: 95 svx dies once warmed up
1) Use spaces properly and punctuation please; so that we can understand you better.
2) If you have a 95 SVX, it is OBD1. If you have read "all the websites and checked the books", then you'll know the black diagnostic connector is located behind the driver side kick panel cover. Refer to SVX-iw for a complete procedure.
__________________
1991 SVX L JDM |
#10
|
|||
|
|||
Re: 95 svx dies once warmed up
Thank you for the tip on SVX-iw. All the books i have and sites i found, had little to no info about the SVX.
|
|
|