SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
Creaking noise when turning and under hard accel.
Recently, my 92 has started to make a creaking noise coming from the right front wheel area. I talked to a couple people, and said it is probably the CV joints, is this a common problem with these cars? Also, when starting from a start under hard acceleration, a loud thumping noise comes from the same area, could this be the bearings or also the CVs?
Any advice is greatly appreciated. Wyn- first post |
#2
|
||||
|
||||
My front axles were going bad when I got the car. I traced the problem to the rewheel drive not working correctly. Turning and acccccccellerating is FUN and causes faster wear to the front CV joints. That is not just on an SVX but on any car, with a front drive system.
__________________
May your transmission live forever. SuperbVehicleXtraordinary Proud sponsor of a 1992 SVX. |
#3
|
||||
|
||||
i have the same problem with the creaking. it just appeared one day after hitting the theater. its very intermittent. is yours constant?
__________________
"That which can be asserted without evidence can be dismissed without evidence." '92 Dark Teal SVX LS-L, >146,000m 3 pedals, 5 speeds., restoration underway. 2012 Honda Insight, slow but cute. |
#4
|
|||
|
|||
Anybody have an idea on how much CV joints would cost to replace?
Any yes, the creaking noise occurs whenever I make a right turn. |
#5
|
||||
|
||||
I was in a hurry to have one of my axles replaced, so I had an Aamco shop do it. The axles on the SVX may be specific to the car, but they're not of any special type.
Anyway, I know it cost less than $200 - maybe less than $150. I'd be perfectly willing to get the parts myself and do it, but I was in a hurry, after all. Plus those axle nuts can be a total ***** to get off the axles.
__________________
2005 RX-8 Grand Touring 2005 Outback 2002 Mercedes-Benz E320 wagon END OF LINE |
#6
|
|||
|
|||
Quote:
i know what u mean but what kinda tool u need to undo them?? big as wrench did not help |
|
|