SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
Transmission speed sensor reinstall question
I pulled the transmission speed sensor out of the transmisson to check it and need to install it. I found when I removed it that there was a convex metal washer that rides on a shoulder just above the transmission drive shaft. When I pulled the washer out I did not notice if the curve was up or down. Anyone done this before?
Also, lining up the tab on the sensor to the groove on the transmisson shaft looks like it will be trouble. Any helpful hints for this? Thanks. |
#2
|
||||
|
||||
Re: Transmission speed sensor reinstall question
The tab should line up on it's own as you spin the sensor in. The curve should face away from the sensor. The rubber part of the washer should go against the sensor.
__________________
"The things you own end up owning you. It's only after you lose everything that you're free to do anything." 92 Pearl White Ls-l (138k) Euro Headlights & Blinkers, 97 Grill, Euro Tail Lights, SS Brake Lines, Stebro Exhaust, Slotted Rotors, Classic Registration 96 Legacy Outback (206k) 5-speed 2.2 Lightweight Crank Pulley, Group N Trans & Motor Mounts SOLD Wanted: Steering Wheel |
#3
|
|||
|
|||
Re: Transmission speed sensor reinstall question
Thank you very much. This will make reinstall much easier than I was going to try.
|
|
|