Gear Firm-Up Unit Schematic - The Subaru SVX World Network

10-26-2016, 09:18 PM

SURTEESS

Registered User

Join Date: Oct 2006

Location: Auckland, New Zealand

Posts: 1,421

Gear Firm-Up Unit Schematic

Someone was after a Gear Firm-Up Unit.

So I would like some people (more than one) to check my reverse engineered schematic of an existing unit - see posting number 8.

If there is a general requirement for PCBs then I could get some bare boards made (supply a BOM so that individually you can buy components from your local electronics shops such as Jaycar etc)

__________________
1995 LSI, Added the following - Gear Firm-Up unit (that I sell) together with Power TCU ROM & Power switch, K&N air filter, SVX side badges (USA type), Rear Deck Blower (JDM type), Side front markers (USA type), Side rear markers (USA type), Middle rear light (USA type), USA OEM Fog Lights fitted into NZ OEM glass (NZ OEM headlights had only reflectors fitted) Full set of yellow (90SH) Polish bushes includes 15 min mod, R1 Concepts drilled/slotted/gold finish rotors & Red covered braided brake lines (both from Dayle at Motorsport warehouse), EBC Redstuff brake pads. Full SVX bra (only used for shows). Koni adjustable inserts fitted inside OEM strut body, Zoom lowering springs (2" lower), OEM headlight washers fitted.

Last edited by SURTEESS; 11-01-2016 at 03:01 PM. Reason: updated pdf attachment

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -6. The time now is 12:23 AM.