Crank Pulley Separated

[kwren]

ouch

Keith

[oab_au]

That pulley has been loose for a while, must have had a knocking noise at idle?
Clean the key ways, fit a new key, and assemble with some Loctite 641 or similar product for key way fitting.

Harvey.

[tiv0]

Originally Posted by oab_au

That pulley has been loose for a while, must have had a knocking noise at idle?
Clean the key ways, fit a new key, and assemble with some Loctite 641 or similar product for key way fitting.

Harvey.

There was a slight knocking at idle; it wasn't loud enough that it worried me, but now it makes sense.

Can I purchase the key from Subaru?

[oab_au]

Originally Posted by tiv0

There was a slight knocking at idle; it wasn't loud enough that it worried me, but now it makes sense.

Can I purchase the key from Subaru?

I suppose so, or you can file up one, to be a snug fit, then use this Loctite
232, it's better for the job than 641, to fill and the extra space so it won't move again.

Harvey.

[dannmarr]

Originally Posted by kwren

Never thought of that one for the axle.
Give me a few minutes to wake up here, but I don't recall and "left hand threads on either side... seems like they are all right-hand threads.

Keith

LOL! I should have said drive in reverse for the Driver side and forward for the passenger side.

[dragoontwo]

Originally Posted by dannmarr

LOL! You are correct, I should have said drive in reverse.

That will only work for the drivers side........

[IppoJ]

Originally Posted by tiv0

My parents were down here in AZ visiting this last week, and they drove my SVX a couple days ago. When I came home from school, I went to move my car into the garage and noticed I had no power steering and a few of my dash lights were illuminated. I opened the hood and both accessory belts were in pieces.

I didn't do it!

[tiv0]

Just want to verify this, I posted a WTB thread on nasioc and found a guy in my area with a pulley available. I noted that the pulley can be from any ej20, 22, or 25 engine and got a response fairly quickly. The seller tells me this is from a wrx/sti and I want to make sure it will fit properly before I buy it. Can anyone help me out? I know it doesn't look identical to our stock one, but I didn't expect that it would.

[1986nate]

pictures aren't showing up for me.
But, as long as it's not an underdriven crank pulley, it'll work.

[tiv0]

Ok.

Yeah I didn't know if the pictures were going to work. First time attempting to post pictures using my iPhone browser.

[92 SVX]

I have a stock 92 pulley i took it off because i got a great deal on a one piece aluminum one I'll post a pic

[92 SVX]

ok front and back pics

[tiv0]

Pictures updated in post 38.

[Darren]

That will fit no problems, it looks like an EJ25 one.

[tiv0]

Originally Posted by Darren

That will fit no problems, it looks like an EJ25 one.

Yep, picked it up last night and checked the fit. Only $15 too

Only thing left to do is get a new key and install in the end of the crankshaft, then it's just a matter of putting everything back together.