SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#31
|
||||
|
||||
who are u getting the X-member from?? and why??
Tom |
#32
|
||||
|
||||
Quote:
I have my old one laying around somewhere, but I'm not sure how much it can take. It may be fine, I just didn't like it but may have been a little overparanoid when I took it off.
__________________
-Mike ECUTune2v7 - 4.11 5 Speed - Sprung 6 Puck Clutch - D&S Rotors - SS Brake & Clutch Lines - HKS Panel Filter - HeaderBack Exhaust -80GB Hard Drive - GroupN Engine Mounts - - some other "tricks"
[SIGPIC][/SIGPIC] In progess: track down mystery noise <-identified, paint the new dash, get better pic Spring plans: Replace Trans - Integrate ECU with the carputer - Suspension - Go back to STI Filter - Paint? Maybe not - Next Oil change: Purolator L30165 Member #995 | My Locker | My New Locker Catch you next at: ? Auto-X ? |
#33
|
||||
|
||||
did he say he wanted to go with an MT??
Tom |
#34
|
||||
|
||||
Quote:
__________________
-Mike ECUTune2v7 - 4.11 5 Speed - Sprung 6 Puck Clutch - D&S Rotors - SS Brake & Clutch Lines - HKS Panel Filter - HeaderBack Exhaust -80GB Hard Drive - GroupN Engine Mounts - - some other "tricks"
[SIGPIC][/SIGPIC] In progess: track down mystery noise <-identified, paint the new dash, get better pic Spring plans: Replace Trans - Integrate ECU with the carputer - Suspension - Go back to STI Filter - Paint? Maybe not - Next Oil change: Purolator L30165 Member #995 | My Locker | My New Locker Catch you next at: ? Auto-X ? |
#35
|
||||
|
||||
thats where I was confused... ok then
Ton |
#36
|
||||
|
||||
Yeah, I did take that to mean that you would still make them. The plan is eventually to go MT and I was reading your post to mean that maybe I should take advantage of getting the X-member while I still could too.
__________________
Former: 1994 Barcelona Red(x2), 1995 Brilliant Red, 1992 Liquid Silver, 1992 Ebony(x2), 1992 Pearl White (x2) Current: 2017 Ford Raptor 2017 Kawasaki KLR 1995 Guards Red Carrera 1995 Spec-ish Miata - track car 1957 CJ-5 |
#37
|
||||
|
||||
Alright, everything is shining clean and the spacers should be here by the end of the week or beginning of next week. I am thinking that while I have the top intake, stacks and fuel rails off I am going to change my plugs. It makes it a lot easier with all of that stuff not interfering. My next question was this: should I do the cams while this stuff is still off and there is more room to work. Also, if I should what is the best change in lift and duration for an EG33 that is going F/I. I have seen a lot of ###'s thrown around, but nothing conclusive.
__________________
Former: 1994 Barcelona Red(x2), 1995 Brilliant Red, 1992 Liquid Silver, 1992 Ebony(x2), 1992 Pearl White (x2) Current: 2017 Ford Raptor 2017 Kawasaki KLR 1995 Guards Red Carrera 1995 Spec-ish Miata - track car 1957 CJ-5 |
#38
|
||||
|
||||
Also, what are flow rates for the injectors in the VG30DE motors?
__________________
Former: 1994 Barcelona Red(x2), 1995 Brilliant Red, 1992 Liquid Silver, 1992 Ebony(x2), 1992 Pearl White (x2) Current: 2017 Ford Raptor 2017 Kawasaki KLR 1995 Guards Red Carrera 1995 Spec-ish Miata - track car 1957 CJ-5 |
#39
|
||||
|
||||
Listen, you are not going to want to toss some cams for a turbo motor in there while it is N/A. It will put a damper on performance before it does anything else. Next, I am not sure what the flow rates are for the 300zx injectors but since you do not have the programming capabilities to make them work properly, I wouldn't advise it
Tom |
#40
|
||||
|
||||
The car isn't going to be driven until it's all done first of all. So, a "damper" on performance is no concern. I was just thinking that it may be easier to do the cams now before everything is put back. Also, I will be getting the stage 2 v.6 now that is available to take care of the programming.
__________________
Former: 1994 Barcelona Red(x2), 1995 Brilliant Red, 1992 Liquid Silver, 1992 Ebony(x2), 1992 Pearl White (x2) Current: 2017 Ford Raptor 2017 Kawasaki KLR 1995 Guards Red Carrera 1995 Spec-ish Miata - track car 1957 CJ-5 |
#41
|
||||
|
||||
you are not hearing me correctly. You cannot use the 300zx injectors.... period. The stage2v6 is meant to be used with SVX injectors. as for a turbo cam profile, I am not the one to talk to... try shooting PhastSVX a PM he may know better
Tom |
#42
|
||||
|
||||
So, with the 2v6 I am limited to whatever limit the stock injectors max out at?
__________________
Former: 1994 Barcelona Red(x2), 1995 Brilliant Red, 1992 Liquid Silver, 1992 Ebony(x2), 1992 Pearl White (x2) Current: 2017 Ford Raptor 2017 Kawasaki KLR 1995 Guards Red Carrera 1995 Spec-ish Miata - track car 1957 CJ-5 |
#43
|
||||
|
||||
until you go with the stage 3 or use your own system with either and additional injector controller or a standalone
Tom |
#44
|
|||
|
|||
Quote:
Harvey.
__________________
One Arm Bloke. Tell it like it is! 95 Lsi. Bordeaux Pearl, Aust. RHD.149,000Kls Subaru BBS wheels. 97 Liberty GX Auto sedan. 320,000Kls. 04 Liberty 30R Auto Premium. 92.000kls. |
|
|