power mode still/again

[oab_au]

Joe, Phil, this sounds like the reverse of the problem that -JJ- had, when he replaced his Euro box with a JDM box. Might be worth looking at what happened there. He even had the Solenoid 3 code.

Harvey.

[svxistentialist]

Originally Posted by b3lha

From looking at the diagrams, you should be able to test using a digital meter set for low voltage AC.

To test sensor 1, measure the voltage across pins 9 (black) and 16 (white) of plug T2.

To test sensor 2, measure the voltage across pins 14 (black) and 15 (white) of plug T2.

In actual fact, pins 9 and 14 are grounds and are connected together, so you can measure 14-16 and 14-15 if it's easier.

The book says the voltage should be > 1 volt AC. I wouldn't expect it to be much more than that.

I think I asked you this before: Have you checked the "shield joint connector" B69 that connects all the transmission signal earths together.

You have. I did. These seem to be a number of earths conjoined together, and also a number of sleeves or shields, conected together.

They all seem OK.

So if I get greater than 1V ac, both sensors are outputting OK?

Joe

[b3lha]

Originally Posted by svxistentialist

So if I get greater than 1V ac, both sensors are outputting OK?

That's how I read it.