SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
Wheel Well Moldings
The rubber moldings around my rear wheel wells are distorting and coming out of place in a couple of locations. This is allowing water, salt etc. to get into the seam under the rubber, which is causing rust.
The molding is clipped at both ends where the bumper attaches and where the plastic side panel attaches. Is it a big deal to replace the molding? Seems like you have to disassemble a lot. Any special tools needed? |
#2
|
|||
|
|||
Not a big deal to replace the molding. If I recall correctly, two screws and slip fit. Easy job.
__________________
If it ain't broken it, doesn't have enough features!!! '92 SVX LSL '03 4Runner '96 FZJ80 Landcruiser '90 Mercedes 300E |
Thread Tools | |
Display Modes | |
|
|