The Subaru SVX World Network   SVX Network Forums
Live Chat!
SVX or Subaru Links
Old Lockers
Photo Post
How-To Documents
Message Archive
SVX Shop Search
IRC users:

Go Back   The Subaru SVX World Network > SVX Main Forums > Technical Q & A

Reply
 
Thread Tools Display Modes
  #1  
Old 05-17-2004, 08:49 AM
mbtoloczko's Avatar
mbtoloczko mbtoloczko is offline
sans SVX
 
Join Date: Sep 2002
Location: Richland, WA
Posts: 4,250
Send a message via AIM to mbtoloczko
driveshaft angles measured

Also while I was under the car this weekend, I measured the angles between each section of the driveshaft. Relative to the pinion shaft in the rear diff, the engine is tilted about 4 degrees back (yes the engine really is tilted back). The angle of the front section of the driveshaft appears to be designed to be at zero degrees tilt relative to the engine. Then it looks like the angle between the front and rear sections of the driveshaft are designed to be at about 2 degrees. The angle between the rear section of the driveshaft and the pinion shaft in the rear diff appears to be designed to be at 2 degrees.

The equal angles at two successive u-joints represent the classic design to cancel varying angular velocity caused by a angled u-joint. So, it looks like Subaru did their homework. Anyhow, for those of you who have read up on driveline theory, I thought you might find this interesting.
__________________
Mychailo
:: 2006 Silver Mitsubishi Evolution 9, E85, 34 psi peak, 425wtq/505whp DJ ::
1995 Laguna Blue SVX L AWD 5MT (sold)

Visit my locker

SVX Mods: ND iridium spark plugs, Impreza RS fpr, afr tuned to 13.2:1 using a custom MAF bypass, custom exhaust, WRX 5MT w/ STi RA 1st-4th gear & stock WRX 5th gear, Exedy 13 lb flywheel & Sport Clutch, STi Group N tranny & engine mounts, urethane spacers in rear subframe, rear diff mounts, and pitch stopper, SVX Sport Strut Springs (185f/150r), custom 19 mm rear swaybar, urethane swaybar mounts, Rota Torque 17x8", 225/45-17 Proxes 4 tires, Axxis Deluxe Plus organic brake pads.
Reply With Quote
  #2  
Old 05-17-2004, 09:08 AM
SVXRide's Avatar
SVXRide SVXRide is offline
Official AutoX Part Breaker
Subaru Gold Contributor
 
Join Date: Aug 2002
Location: Midlothian, VA 23112
Posts: 8,138
Registered SVX
Mychailo,
We're going to have to have a talk with your fiance...she's obviously doesn't have any idea of how you're spending your time on weekends
Thanks for the interesting info. So, how does this factor in with your custom driveshaft efforts?
-Bill
__________________
Retired NASA Rocket Scientist

Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023

Center Network Member #989

'92 Fully caged, 5 speed, waiting for its fully built EG33
'92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension
'92(?) Laguna, 6 spd and other stuff (still at OT's place)
My Locker
Reply With Quote
  #3  
Old 05-17-2004, 09:21 AM
mbtoloczko's Avatar
mbtoloczko mbtoloczko is offline
sans SVX
 
Join Date: Sep 2002
Location: Richland, WA
Posts: 4,250
Send a message via AIM to mbtoloczko
With the equal angles, this means that the best driveshaft for the car is not the one with the CV joint in the center, but the one with a u-joint in the center. For the 5MT people, I think its important to make sure that all the angles are correct after the 5MT swap. The angles were off a little bit for mine even though it appeared that the engine was at the same tilt as before the 5MT swap. I was able to equalized the angles by shimming the carrier bearing with two thick washers to drop the carrier bearing down a little bit. Alternatively, I could have shimmed the rear transmission to bring it up a little bit. The carrier bearing was easier, so I took that option.
__________________
Mychailo
:: 2006 Silver Mitsubishi Evolution 9, E85, 34 psi peak, 425wtq/505whp DJ ::
1995 Laguna Blue SVX L AWD 5MT (sold)

Visit my locker

SVX Mods: ND iridium spark plugs, Impreza RS fpr, afr tuned to 13.2:1 using a custom MAF bypass, custom exhaust, WRX 5MT w/ STi RA 1st-4th gear & stock WRX 5th gear, Exedy 13 lb flywheel & Sport Clutch, STi Group N tranny & engine mounts, urethane spacers in rear subframe, rear diff mounts, and pitch stopper, SVX Sport Strut Springs (185f/150r), custom 19 mm rear swaybar, urethane swaybar mounts, Rota Torque 17x8", 225/45-17 Proxes 4 tires, Axxis Deluxe Plus organic brake pads.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 10:11 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122