Neons Selection & Installation

[wawazat??]

Originally posted by SVX-FF

Just a note of caution, do not mount the power supply box on the passanger side strut tower. Everytime I tunr my noens on it messes with my ABS brakes.

Steve

That's scary Steve.

[SVX-FF]

Originally posted by wawazat??


That's scary Steve.

Not that scary, the ABS only activate at 5mph and then shut off. It is more of a anoyance than anything.

Steve

[SVX-FF]

Holy flying pigs!!!!!!
That was my 400th post !!!!

Steve 401

[rob_4187]

For anyone that used the optx kit...Did you wire a ground for the switch? I think i see a little slit for a ground wire to go in but im not sure. I hope that this is the case.

[wawazat??]

Originally posted by SVX-FF


Not that scary, the ABS only activate at 5mph and then shut off. It is more of a anoyance than anything.

Steve

What scares me is that you are willing to install a decorative item that messes with your brake system in any way

To each his own I guess...

Todd

[pavanbabut]

Originally posted by rob_4187
I got the optx neon kit and installed it for the most part but when i hooked up the switch the fuse blew. I took it out and left it unplugged and put the wires on my battery terminals and when i turned the battery on it blew again. I put a nail in touching both parts of the fuse plug and it didnt light up. when i looked on the diagram it shows the switch with a battery wire, a wire to the box, and a ground, but there is no ground wire on it. Any suggestions to why my fuse is blowing and what to do about the ground?

Hi Rob,

If u dont mind can u give post a close up picture of ur side neon tubes, so that i can see how u have installed on sides... thanks,
Pavan.