SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#24
|
||||
|
||||
Quote:
Phil is probably getting good power because he is keeping the boost low. Using race fuel will also help, less tendency to detonate. As Mychailo says, the fine water spray mist helps cool the charge, which in turn reduces detonation, and lets the ECU run things without retardation. This gives more power. Water is actually better than methanol, because it requires more energy to evapourate it than methanol does. Thus it absorbs more heat, cools the cylinders better. Methanol on the other hand will improve the Ron rating of the fuel mixture, so is a help to improve the burn rate of the mixture, as well as absorbing heat. For ordinary road use, a mix somewhere between 25% and 50% methanol would be a good compromise, but pure water would be 100% OK at lowish boost levels. If you are going to very high boost levels, 10-15-20 lbs, the sheer amount of heat you are adding here [which is also a function of the efficiency of your blades, not just based on the pressure you are adding], this heat is not possible to remove by water injection alone, at least not without high pressure pumping of large volumes. This is just not practical. The sensible route is probably to lower the CR for higher boost. In addition, water injection is probably easier to install on our SVXs for boosts in the 6-10 lbs region, and would not need a huge reservoir. You will probably need both injection and an IC if you go for higher boost levels. Joe
__________________
Black Betty [Bam a Lam!] '93 UK spec, still languishing Betty Jersey Girl Silver '92 UK [Channel Isles] 40K Jersey Girl @ Mersea Candy Purple Honda Blackbird Plum Dangerous White X2 RVR Mitsubishi 1800GDI. Vantastic 40,000 miles Jersey Girl |
|
|