SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
Idea of what is leaking drivers side?
lower part of the engine. I havent had all that much time to look yet, but is there a known issue over there some where?
Thanks car looks funny with out a trans in it. Greg Last edited by nexus_7; 08-27-2007 at 09:41 AM. |
#2
|
||||
|
||||
Two common areas are the cam cover gaskets, or the cam shaft gaskets on the front.
__________________
Dave - 03 Baja - 92 SVX - 86 Brat - 08 OB 3.0 |
#3
|
||||
|
||||
+1 to hocrest on that.
Both of mine are leaking as well.
__________________
*No SVX at the moment...* 1987 Winnebago Elandan 35' 2001 Yamaha Roadstar 1600 2004 Ford Excursion Eddie Bauer, 6.0litre Power Stroke Diesel - Daily Driver. Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways, scotch in one hand, body thoroughly used up, totally worn out and screaming HOOOOYA !!!!! |
#4
|
||||
|
||||
Valve cover gasket maybe? mine leaked on driver side only on the part closest to the radiator
__________________
Seth 94' Barcelona Red w/ Tricoat black 2-tone AWD Ls -Sold Mods:AWD conversion/4.44 swap by Budfreak, Custom red interior lights, Custom Satin black dash, Power mode switch, Cold air intake, Permecool tranny filter,Sony xplode 10" sub, Sony xplode 1000w amp, Blitz in-line driver, DDM Tuning 6000k HID's, New paint job/body work by me, 97' Grill, QC shift kit, 17'' MB Motoring rims, 15&20 min mod, front & rear urethane swaybar bushings, Custom fiberglass sub box, Custom red led a/c control unit, perrin lightweight crank pulley, Black wrinkle finish powdercoated intake manifold w/ clear hoses , 02' outback heated/power black leather seats Soon to come:Fiberglass hood, upholster ALL suede to black leather Past subies: 92' Pearl White/black top LS-L-SOLD 96' Legacy Outback-TOTALED 99' Legacy Outback Limited 30th anniversary edition-TOTALED 98' Forester L -Totaled Other toys: 99' Forester S -WRX brake upgrade, soon an 04 wrx motor swap 06' B9 Tribeca-Stock 1982' Yamaha xj650 Maxim Mods: work in progress |
#5
|
|||
|
|||
It is a huge mess under there. Only really noticed how bad it is now that the trans is off.
How hard are these to do? And should I just do both sides? Thanks Greg |
#6
|
||||
|
||||
before you put the tranny back in i would do the rear main seal and remove the plastic cover on the right side of the block and reseal that as well.
__________________
Eric Rebuilt P/S pump info... http://www.subaru-svx.net/forum/showthread.php?t=50918 If your car wont start info... http://www.subaru-svx.net/forum/show...ighlight=click |
#7
|
|||
|
|||
ok, I have never done anything like this before, this sure is fun though.
Greg |
#8
|
|||
|
|||
Just ordered all the valve cover gaskets...and cam gaskets...and ps pump O ring.
Greg |
Thread Tools | |
Display Modes | |
|
|