The Subaru SVX World Network   SVX Network Forums
Live Chat!
SVX or Subaru Links
Old Lockers
Photo Post
How-To Documents
Message Archive
SVX Shop Search
IRC users:

Go Back   The Subaru SVX World Network > SVX Main Forums > Technical Q & A
Register FAQ Community Calendar Today's Posts Search

Reply
 
Thread Tools Display Modes
  #1  
Old 06-17-2019, 03:22 PM
PacoDeth PacoDeth is offline
Registered User
 
Join Date: Oct 2015
Location: Nicholasville, KY
Posts: 6
Sunroof drain tubes location and clogged

So the front drivers side drainage tube for the sunroof appears to be clogged and is letting water into the car.

I've tried running trimmer line and a plastic coated wire cable but cannot clear the clog. The wire goes pretty far down into the tube from the sunroof entry point, but then stops.

So my first question is where is the exit point under the car where this tube lets water out from as I have thus far been unable to find it.

Secondly, how do you get the pillar material off to inspect the tube where it runs down the car door above the window?
Reply With Quote
  #2  
Old 06-18-2019, 09:35 PM
svxcess's Avatar
svxcess svxcess is offline
Super Moderator
Alcyone Gold Contributor
 
Join Date: Feb 2001
Location: Westminster, MD
Posts: 6,747
Significant Technical Input Registered SVX Classic SVX
Re: Sunroof drain tubes location and clogged

.
You can check the drains first by taking a 1 gal size jug full of water, opening your sunroof all the way and pouring the water by the corner of each side at the front of the sun roof slowly it and will fill up fast. Also make sure your on the 2 of the sunroof guide /rail. The water should come out just behind the front wheels and the rear of the rear wheels . The tubes for the drain run down the front "A" pillars (front) and down the "D" pillars (rear) The exit through each wheel arch just under the inner fender liner




The gasket you are looking for is actually a Butyl sealer (black) simalar to what they use to seal windsheilds with.

The sealer is just under the guide/rail and the frame that mounts to the body

What happens is the sealer dries out and cracks and lets the water from the outside of the guide/rail into the inner part of the sunroof on to the sun shade and down the back of your neck when you hit the brakes or round a corner


Many years ago I remember trying to fix a drain issue in my Pearlie As I recall, I removed the A pillar plastic trim and the two sun visors and passenger side handle and then pulled down on the headliner to reveal that the plastic drain pipe for the sunroof was no longer attached to the drain spouts.

For some reason they shrunk by about an inch so all of the water from the sunroof was draining on top of the headliner then down the A pillar plastic trim into the passenger and driver footwells.

I fixed the problem by going to Home Depot and buying some 1/2 inch inside diameter plastic pipe and two plastic barbed fittings for joining the original and the new plastic pipe to extend the tube to reach the drain on the sunroof.
Attached Images
File Type: jpeg A2A19BBD-F516-4518-9F6C-99052E2792F4.jpeg (105.3 KB, 6616 views)
__________________
.
Subaru Ambassador

1996 Polo Green LSi #216..138,100 miles...SOLD

JFICX8659TH100216.....Date of Manufacture: November 16, 1995.....
Fuji Heavy Industries..Ōta North Plant....Ōta City,. Gunma Prefecture, Japan

In-Service Date: January 2, 1997



"The Pristine Green Polo Machine”
First Polo Green on the Network
First Clear front turn signals, JDM Alcyone hood emblem, rear panel, and BOXER engine cover on the Network (US) (2000)
First 5000K HID factory fog lights (2007)
First SVX JDM BBS wheels on a USDM SVX (2013)

HID lighting (5000K) for headlight and H3 fog lights, PIAA SuperExtreme 120W high beams, rebuilt EG33 longblock, Cometic head gaskets, Phase II flexplate, AMR aluminum radiator with custom silicone hoses, 160A high-output alternator in aluminum-ceramic coated case, new design alternator wiring upgrade v.4, rare factory headlight protectors, refinished JDM BBS mesh aluminum wheels and custom, polished billet aluminum new hex center caps, LED grille mod, R1 Concepts high-carbon cryo slotted rotors, Akebono ceramic pads, Goodridge S/S braided brake lines, Smallcar Stage 1 shift kit, ThermalTech aluminum/ceramic-coated valve covers, Energy Suspension urethane front & rear swaybar bushings, Bontrager22 rear swaybar with QS Components Chromoly Teflon/Kevlar endlinks, "$15.00/5 minute" suspension mod. Hella Supertone horns, Custom stainless steel exhaust system with 2" headpipes, Magnaflow cats, AeroTurbine AR25 resonator /AWD "Bullet" muffler.


R.I.P. 2010 Subaru Outback Limited 2.5 CVT...338,000 miles. Totaled by a 1,300 lb. COW March 4, 2016

2014 Hyundai Avante Limited ...178,000 miles. Actually quieter and smoother than the Outback

2007 Mazda Miata MX-5 PRHT...102,000 miles.
Plenty of parts, service and windshields.


4th Registered Network member —2/21/2001

My NEW locker..I...My Email..I..Wikipedia/SVX .

.
Reply With Quote
  #3  
Old 06-19-2019, 12:24 PM
PacoDeth PacoDeth is offline
Registered User
 
Join Date: Oct 2015
Location: Nicholasville, KY
Posts: 6
Re: Sunroof drain tubes location and clogged

Had the car lifted up, tire off, inner wheel well plastic liner removed, and still for the life of me couldn't find the water outlet.

But I think my biggest problem is I can't figure out how to get the A-pillar trim removed. It looks like it's attached my screws I don't know how to get to.
Quote:
Reply With Quote
  #4  
Old 06-19-2019, 02:43 PM
SoCoNoHa's Avatar
SoCoNoHa SoCoNoHa is offline
H6 Fanatic
 
Join Date: Nov 2016
Location: Southern NH
Posts: 99
Registered SVX
Re: Sunroof drain tubes location and clogged

I do believe they're 'pop-its' or something. They are usually brutal to pull out and often break on older cars like ours. Just pull really hard. Maybe wait for someone else to chime in anyway...
__________________
1992 SVX LS-L : King of the Stable
LGT 5MT, ABS Delete, Short Ram Intake, Custom Exhaust, Drilled/Slotted Rotors

1993 Legacy sedan : winter beater, supposedly.
1994 Legacy wagon : future drift car?
1995 Impreza coupe : EZ30++, daily racecar.
1997 Legacy GT : date night rocket?
2003 WRX : future winter beater
Reply With Quote
  #5  
Old 06-19-2019, 07:05 PM
PacoDeth PacoDeth is offline
Registered User
 
Join Date: Oct 2015
Location: Nicholasville, KY
Posts: 6
Re: Sunroof drain tubes location and clogged

I had thought that, but as best I can tell it's a metal screw with a Phillips head on it
Reply With Quote
  #6  
Old 06-21-2019, 05:59 PM
PacoDeth PacoDeth is offline
Registered User
 
Join Date: Oct 2015
Location: Nicholasville, KY
Posts: 6
Re: Sunroof drain tubes location and clogged

Still for the life of me can't figure this out. Anyone wanna do me a solid and take a poke at their drivers side a pillar trim to see if you can figure out how it comes off?

Here's a better pic of the screws that I think are giving me issue.
Reply With Quote
  #7  
Old 06-28-2019, 05:21 PM
PacoDeth PacoDeth is offline
Registered User
 
Join Date: Oct 2015
Location: Nicholasville, KY
Posts: 6
Re: Sunroof drain tubes location and clogged

Alrighty got the trim off with a healthy dose of force, but the sunroof drain tube wasn't exposed under it like I was hoping.

Anyone know exactly where the drain tube exits under the car? The image in the mechanic manual hasn't helped me find it with my own eyes.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 08:07 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
© 2001-2015 SVX World Network
(208)-906-1122