Live Chat!
SVX or Subaru Links
Old Lockers
Photo Post
How-To Documents
Message Archive
SVX Shop Search
|
SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
|
#1
08-27-2014, 04:50 AM
|
||||
|
||||
|
Rear axle question
Was trying to loosen cover plate on inner end of rr axle as it goes into the diff, held with 5 12mm bolts. With bolts off and a goodly bit of prying, it didn't budge. Is this a matter of needing to "persuade" it a bit more vigorously or am I missing something?
THX 
|
|
#2
08-27-2014, 03:57 PM
|
||||
|
||||
|
Re: Rear axle question
After you remove the 5 EIGHT MM bolts with the TWELVE MM heads, gently try to rotate the side plate using a square drift, if you have one and a small hammer.
Once you start to twist it/rotate it it should be able to be twisted off.
__________________
www.svxfiles.com The first SuperCharged SVX,  the first 4.44 gears, the first equal length headers, the first phenolic spacers, the first Class Glass fiberglass hood, the first with 4, 4.44s in his driveway  Fiberglass Hood thread My locker 4.44 Swap link
|
|
#3
08-27-2014, 04:16 PM
|
||||
|
||||
|
Re: Rear axle question
As always, much appreciated...will follow those tips.
|
|
#4
08-27-2014, 05:11 PM
|
||||
|
||||
|
Re: Rear axle question
Sure.
 BTW, "Torque the side plates to 6.5-8.7 ft/lb."
__________________
www.svxfiles.com The first SuperCharged SVX, the first 4.44 gears, the first equal length headers, the first phenolic spacers, the first Class Glass fiberglass hood, the first with 4, 4.44s in his driveway Fiberglass Hood thread My locker 4.44 Swap link
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
