SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#16
|
||||
|
||||
Chuck, it would appear that you know exactly what you are about and everything put forward so far is simply telling you "how to suck eggs". I hope you have not been somewhat offended.
My interpretation of your post, was that you are aware of the obvious possibilities and are seeking thoughts on any oddity you may not have thought of. I am confident that you would be awake to any cause for a direct link between inlet manifold and sump. I gather you now have no positive crankcase ventilation. You have not reported as to the exact extent of the oil discharge. Could it be that what you are experiencing, is what can in fact be expected in view of the age of the engine? Is the overhead gear receiving too much oil and the return facility therefore inadequate? Possibly this is so and the ventilation is in part, working as a siphon?
__________________
Trevor, New Zealand. As a child, on cold mornings I gladly stood in cowpats to warm my bare feet, but I detest bull$hit! |
#17
|
||||
|
||||
Hi,
Not totally sure of your set up but we had a starlet turbo with a modified turbo runnng higher boost, the engine started throwing oil out of every place it could. The problem was diagnosed as pressure getting into the oil feed pipe from a faulty internal seal on the turbo and finally failing in a cloud of white smoke and bits of turbo all over the place, there was no smoking before it let go. After the new turbo was fitted it never happended again & the car is still going strong and being thrashed by the new owner. |
#18
|
|||
|
|||
Possibilities
Quote:
Oba-au - I do need to take pics of my setup and post them huh . Well the setup is pretty simple actually. PCV off and blocked. Vents venting to atmosphere. The only thing that recirculates are the auxilliary air intake and idle air controller. EGR disconnected and plugged. Should not be too much oil, but simple things like that are good to mention. Trevor - No offence ever taken. I appreciate simple and complex possibilities. Thanks everyone for the ideas. Keep them comming. Another note to Oba-au. No smoke out the tailpipe. Yep I'm perplexed! Thanks for the vote of confidence in my engine! I do get a fuel smell out of my crankcase though. I've checked the injectors for leaks. Checked them out of the intake with the pump on. No leaks. I think one of the problems I am having now is I removed my cold air intake and the breather vents are close to the intake. With all of this air leaking by, it seems that it could be sucked up by the intake, making fuel difficult to control.
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
#19
|
||||
|
||||
Quote:
__________________
Trevor, New Zealand. As a child, on cold mornings I gladly stood in cowpats to warm my bare feet, but I detest bull$hit! |
#20
|
|||
|
|||
Gasket Leak
Quote:
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
#21
|
||||
|
||||
Quote:
Chuck, There has to be a crack/pathway from the combustion chamber to the coolant passages for this to happen. I'm guessing the turbo pressurizing the system is only making it worse. Have you tried using test dye in the radiator? If you're seeing fuel in the coolant, I've got to believe there's also combustion byproducts in it too. -Bill
__________________
Retired NASA Rocket Scientist Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023 Center Network Member #989 '92 Fully caged, 5 speed, waiting for its fully built EG33 '92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension '92(?) Laguna, 6 spd and other stuff (still at OT's place) My Locker |
#22
|
||||
|
||||
downshift!!! If there is a HG leak and compression is leaking to the crank case, downshift it causing a vacum and it should cause smoke to come out the tails
Tom |
#23
|
|||
|
|||
Things to try.
Quote:
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
#24
|
||||
|
||||
Quote:
It's a shame our plugs are such a PITA to get to...it would be nice to be able to do a leak down check on each cylinder. -Bill
__________________
Retired NASA Rocket Scientist Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023 Center Network Member #989 '92 Fully caged, 5 speed, waiting for its fully built EG33 '92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension '92(?) Laguna, 6 spd and other stuff (still at OT's place) My Locker |
#25
|
||||
|
||||
Hiya Chuck,
This might be a bit of help to you. 4.2 Turbocharger "Seals" andCrankcase Pressure The turbocharger “seals” play a secondary role in turbocharger oil control since the oil slingers are designed to prevent oil from reaching the seal areas. The primary role of the turbocharger seals is to prevent external gases (i.e., boost pressure and/or exhaust gas) from entering the center housing. Under most operating conditions in a blow-thru configuration, the gas pressures in the compressor and turbine housings are equal to or greater than the gas pressure in the turbocharger center housing (i.e., engine breather pressure). In this configuration, the pressure on the turbocharger seals is from the outside toward the inside and is actually trying to push any oil near the seal areas into the turbo.[/B] If the engine breather system has been modified so that the engine crankcase cannot breathe and is causing excess crankcase pressure, this pressure is transmitted to the turbocharger center housing via the oil drain tube. In this situation, the crankcase pressure in the turbo center housing may exceed the compressor and/or turbine housing pressure; therefore, the pressure on the turbocharger seals is from the inside toward the outside and the crankcase pressure will push oil out of the center housing into the compressor and turbine housings. Excess crankcase pressure may be caused by engine breather modifications such as improperly installed performance breathers/catch cans or by worn or damaged engine components (i.e., pistons, rings, or cylinder walls) that result in severe combustion gas blow-by that pressurizes the engine crankcase and turbocharger center housing.[/B][/COLOR] Darren |
#26
|
|||
|
|||
Quote:
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
#27
|
||||
|
||||
Oil spewing out
Hey guys - had similar problem with mine a few months ago (it would puff grey smoke at initial stat-up only), I checked PCV valve & all the other standard issues... but to no avail, just could not put my finger on the issue.
Took it along to local agent who has always serviced it for past 10 years (hard to think that I have had it that long!!). He suggested the Aux. air control valve was blocked or not working (this is a non-serviceable part - yeh right!!!). If you are standing in front of car then the AACV is located under the right inlet bank (header pipes) - look between 1st & second ones you will see a round tapered aluminium tube - it has a square base with 4 bolts attaching it to the block (also has 1 - 2way connector at taper end). This operates an aux air supply when the engine is cold, operates on a 12 volt supply operating a bi-metal spring (plus the engine getting warm through the aluminium block casting). When cold the tapered part is fully open, about the size of a NZ 5c piece (dime size) - as the spring & engine warm up then there is a sliding shutter that closes approx 80% off. Sorry guys but my scanner has died last week - but those of you with 1992 service manuals look at book 2/3, section 2-1 (page 3) Emission control system & vacuum fitting, part 15. Same drawing is also in section 2-7 (page 3) Fuel injection system, part 15. Shown fully is in section 2-7 (page 5) AUXILIARY AIR CONTROL VALVE. Mine was full of oil - he explained that this happens when the car is being used for short stop/start trips. I got the old one back - soaked it in kero & tested it with 12v supply, works like new (so have a spare!!). Good luck - from New Zealand. Last edited by SURTEESS; 10-13-2010 at 11:10 AM. |
#28
|
|||
|
|||
Quote:
I may try putting some regular oil in it instead of the synthetic. If nothing happens, I may try some STP I just would like to finish a few things first before rebuilding.
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
#29
|
|||
|
|||
Engine pic
Posted a photo of my engine bay in my locker.
__________________
Chuck D. 1992 Subaru SVX LS-L - Heavily modded turbo 2002 Subaru Impreza WRX- Turboxs stg3 & Susp. Mods |
#30
|
|||
|
|||
Looken good.
Quote:
Harvey.
__________________
One Arm Bloke. Tell it like it is! 95 Lsi. Bordeaux Pearl, Aust. RHD.149,000Kls Subaru BBS wheels. 97 Liberty GX Auto sedan. 320,000Kls. 04 Liberty 30R Auto Premium. 92.000kls. |
Thread Tools | |
Display Modes | |
|
|