SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
door locks
Hey, my door locks won't engage or disengage on the driver's side, any ideas on how to fix em or should I just order a new solinoid?
__________________
98 Impreza Wago-O-Doom & Datsun Roadsters |
#2
|
|||
|
|||
it's probably the motor assembly. Unfortunately, it can't be bought by itself and you have to buy the whole assembly. less than $130 tho, so not TOO bad.
Part # 2 on this page http://www.subaruparts.com/diag/?mod...category=602-A |
#3
|
||||
|
||||
check for a loose connection first.
__________________
David B. SVXipedia @ SVX-IW.COM -- SVX Information Warehouse 2.0 coming...eventually! Ebony 1992 SVX LS-L 5 spd Koni/GC Stebro 187k miles RIP (Rust In Pieces) 1993 SVX 5 spd Koni/GC Stebro Polyurethane bushings still available! |
#4
|
||||
|
||||
its not a loose connection, checked that yesterday.
__________________
98 Impreza Wago-O-Doom & Datsun Roadsters |
#5
|
||||
|
||||
So the plug right by the actuator is getting the proper voltages? Another test is to send power directly to the actuator. That's what I did to determine the short in my door locks.
__________________
David B. SVXipedia @ SVX-IW.COM -- SVX Information Warehouse 2.0 coming...eventually! Ebony 1992 SVX LS-L 5 spd Koni/GC Stebro 187k miles RIP (Rust In Pieces) 1993 SVX 5 spd Koni/GC Stebro Polyurethane bushings still available! |
#6
|
||||
|
||||
Open up the solenoid and check for water inside. If there is some then empty it out and spray the contacts with WD40.
I've had this a few times where it causes the solenoid to stop in a halfway position and then you can't lock or unlock the doors. Phil. |
Thread Tools | |
Display Modes | |
|
|