Intake sub gear

[Stevebsy]

It's not too difficult to put it back to correct.

I just took my heads apart without reading the step on putting the bolt in. Thought I was in trouble, but in the manual it shows how to re-set them when you reassemble it.

You have to pull the cam off of the head to do it, though.

[Huskymaniac]

Originally Posted by Stevebsy

It's not too difficult to put it back to correct.

I just took my heads apart without reading the step on putting the bolt in. Thought I was in trouble, but in the manual it shows how to re-set them when you reassemble it.

You have to pull the cam off of the head to do it, though.

Can you post here or PM me the page in the manual that describes this process? Thanks!

[Stevebsy]

If I recall correctly, you just turn the sub gear until you can put the bolt in and the bolt will hit on the flat spot to hold it in place, but I'll find that section in the book and make sure that's correct.