SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
a gauge cluster question
And pretty easy one to I hope.
How do you get the needles off? Do you just yank them off or what? Id rather not break anything while I try this, so knowing is good -Eric
__________________
R.I.P Cool Signature. You're gone but not forgotten. I mean, sure, I kindof don't remember some of the finer details..but I remember you were funny, and at one point you said spaghetti in Dutch....but definantly not forgotten |
#2
|
||||
|
||||
Quote:
Before removal mark or note the position of the mechanism and pointer, so that you can refit as removed and do not upset the original calibration. You may find a small mark on the face, placed there for this purpose.
__________________
Trevor, New Zealand. As a child, on cold mornings I gladly stood in cowpats to warm my bare feet, but I detest bull$hit! |
#3
|
||||
|
||||
thanks trev, just gave tem a bit harder of tug and they popped right off
__________________
R.I.P Cool Signature. You're gone but not forgotten. I mean, sure, I kindof don't remember some of the finer details..but I remember you were funny, and at one point you said spaghetti in Dutch....but definantly not forgotten |
#4
|
||||
|
||||
A bit of a late post but if you use a small flat screwdriver, you can gently wedge it under the center and the needle assembly will pop straight up and off.
|
|
|