SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
Driver's wiper sticks and is noisy
My driver's side windshield wiper sticks on the left side and kind of goes past window frame edge. I actually have to stick my hand outside while driving to get it unstuck. It gets stuck easiest at slower speeds. Any suggestions?
|
#2
|
||||
|
||||
Remove the cover, the cotter pin and nut on the end of the arm . Then remove the arm and reset it untill it does not go over the edge when fully extended. This might take a few times to get it right. Tip: if you have trouble removing the arm, straighten out the arm by holding down the center while lifting it out. Good luck.
|
#3
|
||||
|
||||
Thank you. I guess I messed it up when I repainted the wiper arms during the summer.
|
#4
|
||||
|
||||
Quote:
__________________
-Mike ECUTune2v7 - 4.11 5 Speed - Sprung 6 Puck Clutch - D&S Rotors - SS Brake & Clutch Lines - HKS Panel Filter - HeaderBack Exhaust -80GB Hard Drive - GroupN Engine Mounts - - some other "tricks"
[SIGPIC][/SIGPIC] In progess: track down mystery noise <-identified, paint the new dash, get better pic Spring plans: Replace Trans - Integrate ECU with the carputer - Suspension - Go back to STI Filter - Paint? Maybe not - Next Oil change: Purolator L30165 Member #995 | My Locker | My New Locker Catch you next at: ? Auto-X ? |
#5
|
||||
|
||||
You are correct, no cotter pin. That was my Dodge.
|
Thread Tools | |
Display Modes | |
|
|