SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
||||
|
||||
Very Bad rattling??
Ok I have always had a slight rattle (sounds very tin like) from underneth the center of the car, this is after removing the noisy heat sheilding.
But yesterday i removed the exusaust from the cat back and went for a quick drive...damn it was loud and grubley i loved it haha, any way after the fun i put her back together and the vibration was worse.... a lot worse i now have a rattle across all rev ranges, on full throttle it stops but on full back off it is embarasingly noisy....any ideas? Could the contence of the cat be loose???
__________________
1992 Pearl / Black SVX removed intake silencer, k&N pannel filter, trans cooler, 94 JDM 4eat, Noltec front swaybar mounts, Motorsport D&S disks with EBC Greenstuff pads |
#2
|
||||
|
||||
Could it be the resonator?
Get under the car (safely) with a rubber mallet and start banging away until you find the rattle.
__________________
David B. SVXipedia @ SVX-IW.COM -- SVX Information Warehouse 2.0 coming...eventually! Ebony 1992 SVX LS-L 5 spd Koni/GC Stebro 187k miles RIP (Rust In Pieces) 1993 SVX 5 spd Koni/GC Stebro Polyurethane bushings still available! |
#3
|
||||
|
||||
I FOUND IT!!
The heat shield that is directly over the center baring on the rear drive shaft had lowered so it was just rubbing on the join, made a helovaraket hehe, got a screw driver and bent it out of the way, since doing that i have driven and it has lowered again, might weld it up or something
__________________
1992 Pearl / Black SVX removed intake silencer, k&N pannel filter, trans cooler, 94 JDM 4eat, Noltec front swaybar mounts, Motorsport D&S disks with EBC Greenstuff pads Last edited by -JJ-; 12-07-2005 at 05:54 AM. |
#4
|
||||
|
||||
Quote:
|
|
|