Headers ????

[superdave555]

there's not really any way to be sure unless you can test fit them, they were made for an EG33 engine in a WRX.

[Johnybeas]

this is a similar design to what I plan to use on my SVX when I turbo it

[Johnybeas]

after a closer look at those and the headers tom has done in the past I think that I will use a semi hybrid design between those and his, I plan to leave the exhaust manifold the way tom has and put my flow more angled toward the center of the vehicle collect from 6 to 2 for the headers and then have the second piece be a 2 to 1 in a y pipe just in front of the crossmember and then over to the turbo for the up pipe.

edit:

essentially I want to do a shorter version of rally bob's

[httrdd]

Where are these from?