Headers ????

[SURTEESS]

http://www.trademe.co.nz/Trade-Me-Mo...-284831013.htm

Not mine (and not thinking about getting them) - but thought I would ask what (if any) improvements one might expect ??

Stephen (1 OF 1)

[aust92pearl]

interesting ...
someone with extra $$ should buy them and dyno them see if there is an improvment in power or sound lol

[Freeman]

Wow, even I would want them if they weren't so far away.. How much do you think they would be shipped to Maryland?

[httrdd]

Tomsvx has designed a similar style and they are nice. Putting headers on any car will improve the flow of the exhaust gases wich will produce more power. If I had a little extra $ and not trying to buy a house I would buy these ant weld them up for my swap!

[redlightningsvx]

If you read the link they say they are for the EG33 but doesn't mean it will fit in the SVX.

[1986nate]

Originally Posted by redlightningsvx

If you read the link they say they are for the EG33 but doesn't mean it will fit in the SVX.

these r tuned length stainleess steel flows i had on my supercharged 3.3 svx engine,also come with the 3 into 1 colecters ,i also have other spare motor parts ask and i can start another auction

If you look at the design, it is extremely clear that they will fit on an SVX...
These are not like the ones that people sell that were designed for an offroad car or some other setup...

[Freeman]

Well that sucks..

[1986nate]

Originally Posted by Freeman

Well that sucks..

What does?

If you look at the design, it is extremely clear that they will fit on an SVX...
These are not like the ones that people sell that were designed for an offroad car or some other setup...

I hope my editing of my previous post makes it clear as I'm sure you read it incorrectly.

[Myxalplyx]

Question is, why is anyone stalling on getting them if they can fit your ride?

[SilverSpear]

The one fabbed these obviously used the smallcar flanges for them. The one on the right should fit the SVX, while on left, I dunno... might be a camera angle, hope its clearance is good enough to have an acceptable ground clearance.

[1986nate]

Originally Posted by SilverSpear

The one fabbed these obviously used the smallcar flanges for them. The one on the right should fit the SVX, while on left, I dunno... might be a camera angle, hope its clearance is good enough to have an acceptable ground clearance.

Danny, I thought the exact same thing until I looked at the other and noticed they are the same design. I thought to myself, wow, hope he had perfectly flat roads until I looked closely again at things the 3rd time. That one pipe that looks like it would be extremely low is actually "flared" out parallel from the "ground" to remain true and correct equal length between all 3 primaries.

[superdave555]

there's not really any way to be sure unless you can test fit them, they were made for an EG33 engine in a WRX.

[Johnybeas]

this is a similar design to what I plan to use on my SVX when I turbo it

[Johnybeas]

after a closer look at those and the headers tom has done in the past I think that I will use a semi hybrid design between those and his, I plan to leave the exhaust manifold the way tom has and put my flow more angled toward the center of the vehicle collect from 6 to 2 for the headers and then have the second piece be a 2 to 1 in a y pipe just in front of the crossmember and then over to the turbo for the up pipe.

edit:

essentially I want to do a shorter version of rally bob's

[httrdd]

Where are these from?