DIY garage spliter/lip

[Seraphinwolf]

I know it's stupid and cheap(which is the best part) and hardly noticed as much of anything but I got around to doing it and it looks SO much better along the front.

Without it my stance and such still looks good.....


BUT! It's just too plain along the bottom edge. So lets see what we can do about that....

It's nice that we have this urethane guard here that we can straight up attack!

Line up starting from the rear to make sure the lengths are all right and I started from the corner and worked out with the self tapping screws.

You can see I edged it off so it blends into the bumper cover. I did the same in the end to the back edge by the wheels to.

Then TA DAAAA!!!!!

I'll have to remember to get some daylight pics of the whole front all done. I'm gonna "spat" the rear in the same fashion and then turn the stuff upside down and line the edge of the sideskirt area like a accent and double sided tape it to make sure it stays in place along the top against the body. Comments?
-Gaddis