|
Re: What have you done to your SVX (or other Subaru) today?
Tightened up all the sump bolts (engine and gearbox) as well as the in-hex lower bolts around the engine - nice before and after shots of the clean up.
While under the car I noticed that in the past some mechanic took off the heatshield (top and bottom) next to the gearbox ... so lucky I am off to the wreckers tomorrow for a couple of other items.
I think it was rattling because the front mounting point is missing - so at the wreckers I will take a nice hammer and chisel !!!
*UPDATED PHOTOS FROM TODAY ARE LOCATED IN THE DOWN UNDER SECTION*
__________________
1995 LSI, Added the following - Gear Firm-Up unit (that I sell) together with Power TCU ROM & Power switch, K&N air filter, SVX side badges (USA type), Rear Deck Blower (JDM type), Side front markers (USA type), Side rear markers (USA type), Middle rear light (USA type), USA OEM Fog Lights fitted into NZ OEM glass (NZ OEM headlights had only reflectors fitted) Full set of yellow (90SH) Polish bushes includes 15 min mod, R1 Concepts drilled/slotted/gold finish rotors & Red covered braided brake lines (both from Dayle at Motorsport warehouse), EBC Redstuff brake pads. Full SVX bra (only used for shows). Koni adjustable inserts fitted inside OEM strut body, Zoom lowering springs (2" lower), OEM headlight washers fitted.
Last edited by SURTEESS; 09-16-2017 at 03:11 AM.
|