actually it is fairly straight forward.
1. Drop the exhaust out of the way.
2. Disconnect the brake lines from the car.
3. Disconnect the ABS wheel sensors from the car (under the rear seat)
4. Disconnect the parking brake cables from the car (under the center console)
5. Drop all the supporting hardware from the subframe brackets first
6. Use a tall jack or two jacks to support the subframe
7. Disconnect the top strut mounts from the body.
8. Using an impact gun drop the four main supports for the subframe
9. Lower it down (while doing this, be sure there is nothing still connected to the car).
10. You have a subframe on the floor, reverse procedure for install
Tom
|