View Single Post
  #10  
Old 04-19-2005, 12:25 PM
914helo 914helo is offline
Registered User
 
Join Date: Mar 2005
Location: Ridgecrest, CA
Posts: 146
While I've got the engine on a stand I plan on replacing seals, belts, etc. since everything is so accessible. It's low mileage and relatively clean, but unfortunately it's been sitting for almost 5 years (1 year in my garage).
The stand from Harbor Freight was easy to put together. My only complaint was that for the two rear wheels there was only one washer per wheel. The stand sometimes rolled like a bad grocery cart. I bought two washers with a 1/2" center so that there'd be a washer on each side of the wheel and now it rolls very smoothly. Pardon by cheap camera.
Attached Images
File Type: jpg Engine stand.jpg (322.6 KB, 100 views)
__________________
Kent
Reply With Quote