Re: 11:1 Engine Rebuild
Here is a picture of the crank case with crank shaft, rods, and bearings installed. Before installation they were meticulously cleaned along with mating surfaces, then assembled with moly graphite assembly lube per LAN's engine build how-to. In the picture there is some silicone missing around the oil pump area and around the bolt holes. This was corrected before assembly. All bolts were torqued per the FSM.
__________________
Cam
'92 Ls-L Dark Teal
11:1 CR ECUTUNE pistons
ECUTUNE .256 duration intake/exhaust cams
ECUTUNE STAGE 2AV1 ECU
Z32 MAF/SR20DET injectors
Balanced & Blueprinted
Last edited by Cam; 07-21-2010 at 11:18 PM.
|