a good summary of the situation...
http://www.subaru-svx.net/forum/show...threadid=11429
Either way its not hard of a job at all just make sure you have the tensioner all the way over and down good or else it will keep moving and youll be thrown off by a mark or two...(This took me a couple of tries before realizing
)Dont worry if you pull the pin and it isn't right and you dont have a vice to push the pin back in just go to home depot in the tools department and use there vices they have there. Word of caution you are placing EXTREME pressure on the so make sure its in the vice properly. You'll see if when you have to compress the pin.