Hi Trevor
,
When my TPS went bad, had a code, I wanted to know what happened to this thing. So I made a 2" x 3" piece of plywood and mounted the tps in the corner with an arm attached to it. Then I marked off equally spaced angle marks about 2' from the center of rotation. I was able to put it back in the same exact position and check readings. I also cleaned it several times and checked to see if that worked. I also checked the new sensor the same way on the board.
They wear out. I think the conductive plastic is not very thick and the wear makes it thinner.
Take care of that SVX,
John
__________________
May your transmission live forever.
SuperbVehicleXtraordinary
Proud sponsor of a 1992 SVX.