|
Again
Quote:
Originally Posted by kwren
Naturally it will only punch out one direction. The alignment on the shaft and the part out of the transmission must be the same when reinstalling the pin. In otherwise you could slide the 2 components together 2 different ways 180 degrees different, when reinstalling the pin but only one way will work.
Drive the pin up to remove it, making sure proper clearance is available to drive it all the way. the shaft can easily be turned by hand if needed.
Get a good punch and a good heavy hammed and smack it. Baby tapping it will just swell the pin.
Good luck,
Keith
|
LOL--again. I think you should look at a NEW roll pin. I suspect you will see that it is the SAME diameter for the full length. It compresses slightly to form a tight fit in the hole. However, one end does frequently get spread or beatup by improper installation or removal tools. 
Lee
__________________
SVXx2
92 SVX LS-L Silver
92 SVX LS-L Burgundy (structurally challenged with 2792 miles)
96 SVX LSi Red
92 SVX LS Pearl (Parts)
01 F150 4X4 Red
(+6 with other members of the family)
FREEDOM IS NOT FREE
Last edited by lhopp77; 12-31-2007 at 01:32 PM.
|