|
I just did this a few weeks ago and I also pulled my trans apart and am now rebuilding it.
Here's basically what I did.
1. Remove Exhaust.
2. Drain trans and disconnect trans fluid cooler lines from radiator.
3. Remove front drive axles.
4. Remove rear driveshaft
5. Disconnect all wiring harnesses and shift cable.
6. Remove starter.
7. Remove plate for access to torque converter bolts.
8. Remove transmission to firewall stabilizer bar.
9. Remove torque converter bolts by spinning engine over to get to the next one.
10. Remove bell housing bolts and place jack under trans.
11. Remove rear transmission mount.
12. Jack up the front end of the engine to make a better angle for sliding the transmission off the pins.
13. Remove transmission while making sure the torque converter stays connected to the trans.
If I remember correctly, thats the order I did it.
|