[edmsvx]

I have narrowed the beeping down to the remote car starter. Laying on back looking up at the steering column I can see starter module. The interesting thing is this appears to be a plug and play system. There only appears to be a couple of wires that are were added other than the harness. One being the antenna and the other ground. You break one connector under the dash (Four Wire Plug) and plug each one into the harness. This then goes to a single connector that breaks out the ground and the then goes to a connector on the remote starter. Starter is by SANVIP. It has a remote with 3 buttons on it. One starts, the other stops and the other Who knows ??. There is a lot of wear on the third button so it must have done something.

Well after disconnecting the remote start I still have a current drawn of 0.218 Amps. If I pull the clock fuse in the engine compartment it drops off to about 11 milliamps.