Quote:
Originally Posted by Mike621
Well folks, it is coming down to the final weeks of preparation here at Reading. Tom, Eric, and I have been trying to squeeze in time here and there for our personal projects amidst work and other obligations.
Personally, I have committed myself to complete a ridiculous task list prior to our annual gathering. 
For my Claret:
-Pick up powdercoated wheels and have Toyos mounted DONE
-Assemble Engine (Short Block Assembled!  Thanks Tom!*)
-Install Windshield DONE!
-Install Engine
-Install Transmission
-Seatbelt Bolt (missing in action)
-Swap Wheels and Tires DONE
-Finish Engine Cover Project
-Swap in Optima Battery
-Install HIDs
-Renew Registration
-Re-inspect
-Finish McIntosh (OEM equip from Legacy VDC) Audio Install... (Will Not be Done for Reading)
-Full Detail.
For my Ebony (if it goes)
-Align Driver Door DONE
-Re-align door glass
-Install poly diff bushings DONE
-Full Detail
For my '93 (third string, doubt itd be coming...)
-Install cladding on left side (Done!)-Get carpet from OT at Reading?
-Clean headliner 
-Install replacement rear panels (Tonight or Sunday)
-Hope nobody looks too close at Reading! Hopes Dashed!  |
Made more progress this past weekend...
PS Pump w/ Powdercoated tank, pulley, and bracket. Now re-assembled.
I also had a used OEM w/s installed so that I can pass NJ inspection again and I cleaned out my cowl ducting and drains while I was at it. I finally dropped the RX8 spacesaver into the trunk along with a new SVX tool kit.
