Quote:
|
Originally Posted by msvx95
what? so a code is telling me to pull another code? where does it say that?
|
Take my word for it. You know, let me just post what you have to do, so there is no further confusion.
If you start your SVX, and your power light flashes 16 times, that is a WARNING that is saying that the TCU is storing a code, but you still have to pull the code from the TCU. Heres what you need to do:
1. Warm up engine by driving at speeds greater than 12mph.
2. Stop vehicle and turn ignition switch OFF.
3. Turn ignition switch ON and make sure POWER indicator lamp comes on.
4. Turn ignition switch OFF.
5. Move selector lever to D and turn manual switch ON.
6. Turn ignition switch ON.
7. Move selector lever to "3" and turn manual switch OFF.
8. Move selector level to "2" and turn manual switch ON.
9. Move selector lever to "1" and turn manual switch OFF.
10. Partially depress accelerator pedal (to turn idle switch off).
11. Check code as displayed on POWER light. Blinking once every 1/4sec is normal.
Here are the possible codes:
11 Duty solenoid A
12 Duty solenoid B
13 Shift solenoid 3
14 Shift solenoid 2
15 Shift solenoid 1
21 ATF temp sensor
22 Atmospheric sensor
23 Engine revolution signal
24 Duty solenoid C
31 Throttle sensor
32 Vehicle speed sensor 1
33 Vehicle speed sensor 2