[TomsSVX]

Ok... We found out the brembos bolt to our hub. The 5x114.3 rotor also lines up with the caliper on the hub. the dilema is that the caliper is held away from the rotor too much. Thanks to Jman050 I was able to measure what we have here and I know what we will need to make the 4 pots work.

The stock Sti rotor is about 12.8" in diameter... Not too shabby.

The stock Sti caliper is .510 inches or 12.95mm too tall for the Sti rotor. SO this means we need a rotor to be 1.02 inches wider in diameter or 25.90 mm. Do some research for me and try and find a rotor with the same offset dimensions as the Sti with a diamter of 13.83 inches in diameter with at least 60mm of surface area. It needs to be 30mm thick too.

tom